Classification chamber and classification wheel designed jointly by ultrafine grinder, average particle size of powder
The grading chamber and the vertical grading wheel with variable frequency speed regulation designed jointly can stop the grading of product size at low speed without having to equip sieve mesh; the structure of circulating feed not only severely restricts "big particles" but also prevents over-comminution, so that the product size distribution is narrow and the particle size is average; the grading wheel is adopted to prevent the phenomenon that more than 150 meshes of powder is difficult to pass sieve.
The comminution temperature of ultrafine grinder is lower
The phenomenon of "over-comminution" has been prevented. The crushing chamber will not generate excess heat. At the same time, the air duct is set at the feeding end of the crushing chamber (connecting the air conditioner if necessary). Due to the existence of induced air, the temperature during crushing is taken away by induced air, and the installation of circulating water jacket is added to the crushing outdoor jacket to further reduce the temperature generated by crushing.
The powder is totally blocked by negative pressure operation, no leakage occurs during the crushing process, no environmental pollution and low noise.
Round corner design, using fast assembly connection, disassembly and installation cumbersome, easy to clean.
How to take care of the ultrafine grinder?
1. In the process of consumption, it is necessary to check the temperature rise of bearings frequently. When the temperature rise exceeds 50 C, it is necessary to stop the machine for checking, find out the cause and clean up the defects.
2. When the new machine is running, the transmission belt is easy to stretch. We should pay attention to adjusting the proper tightness of the belt to ensure the service life of the belt.
3. Vulnerable parts should be inspected regularly and replaced in time to ensure the quality and quantity of consumption.
4. The wear condition of blades and linings should be checked frequently. If the consumption rate falls after wear, the wear will be changed when the particle size becomes coarse.
5. The main engine and the graded movable bearing are all smooth and greasy. They adopt No. 2 special grease with a degree of 265-295.
6. The grease-changing period of bearings is 2000 hours. The filling quantity of smooth grease is 1/2 (upper) or 3/4 (lower) of the space in the bearing chamber. Never fill with smooth grease too much, otherwise, the bearing temperature will be too high.
7. The changing period of spiral feeder is 4000 hours, adding ordinary calcium-based smooth grease.
This article is supported by the manufacturer of ultrafine crusher. For more details, please click on our official website at http://www.69gege.com. We will provide you with satisfactory service wholeheartedly.